128 OUTSIDE INTERLOCK AXISĬause An axis is interlocked because the interlock function has become active (input signal has turned off). Action Set the correct direction (+, –) using the axis selector buttons. FOR ORIGIN RETURNĬause The axis-movement direction selected with the axis selector button is not correct for the reference-point return in manual operation mode. Action First actuate the handle for manual pulse feed to move the axis back in the opposite direction to the zero-point, and then carry out the zero-point returning operation once again. 126 AXIS HAS NOT PASSED Z PHASEĬause During initial reference-point return following the power-on action, an axis has not passed through the Z phase of the corresponding detector. After that, carry out the zero-point returning operation once again. Action Either extend the length of the proximity-point watchdog or reduce the reference-point returning speed.
125 ILLEGAL AXIS EXISTSĬause During reference-point return, the proximity-point detection limit switch has overrun the position in which the watchdog is mounted. Action Move the tool tip away from the end in manual operation mode.
113 OVER TRAVELĬause The tool tip has reached stroke limit in the direction of the axis corresponding to the displayed axis name. Action Modify the program so that the tool tip may move within the area specified in the software limit parameters.
0 kommentar(er)
